civic wheel bearings help?
civic wheel bearings help?
my little work car needs a set of wheel bearings, its a 99 civic id do them myself but they are press in. ive only done the whole hub assemblys. tips? or wanna do it? i would pay someone who was willing to do it
Re: civic wheel bearings help?
Just take the entire knuckle off and take it to a machine shop and they will press the old bearings out for you and press the new ones in for pretty cheap.
2011 Tacoma TRD Off-Road: 3" Lift - 255/85R16 KM2's - BAMF Rock Sliders - TRD Supercharged
-
- Lifetime Member
- Posts: 2788
- Joined: Sun Jun 07, 2009 8:03 pm
- Vehicle: 1993 Explorer
- Location: Fairmont
- Contact:
Re: civic wheel bearings help?
x2sohcej8 wrote:Just take the entire knuckle off and take it to a machine shop and they will press the old bearings out for you and press the new ones in for pretty cheap.
Re: civic wheel bearings help?
just take the brake caliber and rotor off, then drop off the upper and lower ball joints and pull the whole assembly out?
Re: civic wheel bearings help?
ive dont wheel bearings before and they were whole hub assemblys, very easy to change. this press in has me timid tho,
-
- Lifetime Member
- Posts: 2788
- Joined: Sun Jun 07, 2009 8:03 pm
- Vehicle: 1993 Explorer
- Location: Fairmont
- Contact:
Re: civic wheel bearings help?
yes, basically.tennant34 wrote:just take the brake caliber and rotor off, then drop off the upper and lower ball joints and pull the whole assembly out?
Re: civic wheel bearings help?
i see, that should be pretty easy bamco in morgantown pretty good to press them in?